Realair Duke 60 V2 Landing Gear Fix

[Travis]

Ever have that problem where your left landing gear doesn't extend properly, and you skid across the runway for everyone to laugh at you during a group flight? I have. A relatively simple fix has been found! The place I found it is here: http://forum.avsim.net/topic/431358-...n-duke-b60-v2/
You can either play with the realism settings, OR, just fix it yourself, It worked for me with no problems on a single quick test flight today.

It is just a simple mistake in the Aircraft.CFG file.
Copied and Pasted from the linked site above:

There's an error in the aircraft.cfg, in the [contact points] section:

point.0 =1, 0.82, 0.00, -3.75, 4000, 0, 0.633, 35, 0.13, 1.80, 0.35, 3.1, 3.1, 0, 152, 180 //Tarmac, non-castoring
point.1 =1, -8.04, -5.40, -3.94, 6000, 1, 1.00, 0, 0.30, 2.50, 0.36, 3.1,3,1, 2, 152, 200
point.2 =1, -8.04, 5.00, -3.94, 6000, 2, 1.00, 0, 0.30, 2.50, 0.36, 3.1, 3.1, 3, 152, 200

Replace the comma by a dot, and that's all folks! No need for turning off the crash detection any more!!!

[Kalo]

Thanks Travis! I guess I never noticed this before because I had crash detection off for multiplayer. I turned it on, and saw that the left wheel wouldn't extend. After these changes it fixed it.

I read some of that thread you linked, and someone said it's highly recommended to set the realism sliders to exactly what the manual says...here's a picture from the manual:

[Travis]

Good info to add on this subject Kalo! Thanks!