Ever have that problem where your left landing gear doesn't extend properly, and you skid across the runway for everyone to laugh at you during a group flight? I have. A relatively simple fix has been found! The place I found it is here: http://forum.avsim.net/topic/431358-...n-duke-b60-v2/
You can either play with the realism settings, OR, just fix it yourself, It worked for me with no problems on a single quick test flight today.
It is just a simple mistake in the Aircraft.CFG file.
Copied and Pasted from the linked site above:
There's an error in the aircraft.cfg, in the [contact points] section:
point.0 =1, 0.82, 0.00, -3.75, 4000, 0, 0.633, 35, 0.13, 1.80, 0.35, 3.1, 3.1, 0, 152, 180 //Tarmac, non-castoring
point.1 =1, -8.04, -5.40, -3.94, 6000, 1, 1.00, 0, 0.30, 2.50, 0.36, 3.1,3,1, 2, 152, 200
point.2 =1, -8.04, 5.00, -3.94, 6000, 2, 1.00, 0, 0.30, 2.50, 0.36, 3.1, 3.1, 3, 152, 200
Replace the comma by a dot, and that's all folks! No need for turning off the crash detection any more!!!
You can either play with the realism settings, OR, just fix it yourself, It worked for me with no problems on a single quick test flight today.
It is just a simple mistake in the Aircraft.CFG file.
Copied and Pasted from the linked site above:
There's an error in the aircraft.cfg, in the [contact points] section:
point.0 =1, 0.82, 0.00, -3.75, 4000, 0, 0.633, 35, 0.13, 1.80, 0.35, 3.1, 3.1, 0, 152, 180 //Tarmac, non-castoring
point.1 =1, -8.04, -5.40, -3.94, 6000, 1, 1.00, 0, 0.30, 2.50, 0.36, 3.1,3,1, 2, 152, 200
point.2 =1, -8.04, 5.00, -3.94, 6000, 2, 1.00, 0, 0.30, 2.50, 0.36, 3.1, 3.1, 3, 152, 200
Replace the comma by a dot, and that's all folks! No need for turning off the crash detection any more!!!
Comment