Tweet
Everything in the FMC is on gpu ect under ground connections...
Battery ON
STBY Power ON
Ground Power On
Elec Hyd Pumps Off
Check Fire Protection...Not really needed.
Shift+7 knobs to Nav both.
Yaw Damper On
Fuel Valves Closed
Left Fuel Pump on
Start APU
Window Heat ON
Emergency Lights Armed
Seat Belt Signs on
APU Bus Click ON
AC Recirc Fans AUTO Both
ISOLATION BAR AUTO
Left Packs Auto
Right Packs Off
APU Bleed Off
Engine Bleeds on.
APU Bleed On
Enter Position into FMC
Flaps 0
Cut off levers off
Stab Trim Normal
Set FMC Up.....
--------------------------------Before Start Checklist---------------------------
All 4 fuel pumps ON
Elec Pumps On
Left Pack Off
Open FMC and click wheel chocks removed
------------------------Engine Start-------------------------------------
Starter Switch to the RIGHT
Ing switch Ground
Watch N2 Rise to 22 percent then engine cutoff to idle
Repeat with Left Engine Once Right Engine is stable
Watch EGT Rise
-------------------------------After Engine Start---------------------
Flaps Set
Shift+6 and turn the Generators ON
Pitot Heat ON
Right Pack Auto
APU BLeed Off
Left Pack AUTO....On take of turn packs off
Set ign switch to flt
APU Turned OFF
Check Over Panels
Turn on Exterior Lights
Auto Break RTO
Check Flight Controls
------------------------------------------------------------------------------------
I had wrote this checklist based off of a video I watched and I don't use this at all anymore. If you do some digging around on AVSIM, in their library, they have some good NGX checklists that I currently use.
Battery ON
STBY Power ON
Ground Power On
Elec Hyd Pumps Off
Check Fire Protection...Not really needed.
Shift+7 knobs to Nav both.
Yaw Damper On
Fuel Valves Closed
Left Fuel Pump on
Start APU
Window Heat ON
Emergency Lights Armed
Seat Belt Signs on
APU Bus Click ON
AC Recirc Fans AUTO Both
ISOLATION BAR AUTO
Left Packs Auto
Right Packs Off
APU Bleed Off
Engine Bleeds on.
APU Bleed On
Enter Position into FMC
Flaps 0
Cut off levers off
Stab Trim Normal
Set FMC Up.....
--------------------------------Before Start Checklist---------------------------
All 4 fuel pumps ON
Elec Pumps On
Left Pack Off
Open FMC and click wheel chocks removed
------------------------Engine Start-------------------------------------
Starter Switch to the RIGHT
Ing switch Ground
Watch N2 Rise to 22 percent then engine cutoff to idle
Repeat with Left Engine Once Right Engine is stable
Watch EGT Rise
-------------------------------After Engine Start---------------------
Flaps Set
Shift+6 and turn the Generators ON
Pitot Heat ON
Right Pack Auto
APU BLeed Off
Left Pack AUTO....On take of turn packs off
Set ign switch to flt
APU Turned OFF
Check Over Panels
Turn on Exterior Lights
Auto Break RTO
Check Flight Controls
------------------------------------------------------------------------------------
I had wrote this checklist based off of a video I watched and I don't use this at all anymore. If you do some digging around on AVSIM, in their library, they have some good NGX checklists that I currently use.
Comment